G400P + G400E same server

Hello,

Could I know more your system information? Did you screw down the antennas of the third card?

what info is displaying on the Asteirsk console? Meanwhile, all of SIM cards are not out of service,right?

Can I have your IM contact?

Yes, the antennas are tight. 9,10,12 Only the spans do not work.

dahdi: Telephony Interface Registered on major 196
dahdi: Version: 2.4.1.2
ACPI: PCI Interrupt 0000:0b:00.0[A] -> GSI 16 (level, low) -> IRQ 169
Found an OpenVox G400P: Version 1.1
opvxg4xx: slot 0 is Installed
opvxg4xx: slot 1 is Installed
opvxg4xx: slot 2 is Installed
opvxg4xx: slot 3 is Installed
opvxg4xx: Powering up all spans...
ACPI: PCI Interrupt 0000:05:00.0[A] -> GSI 17 (level, low) -> IRQ 177 <

---

ERRO!
Found an OpenVox G400P: Version 1.1
opvxg4xx: slot 0 is Installed
opvxg4xx: slot 1 is Installed
opvxg4xx: slot 2 is Installed
opvxg4xx: slot 3 is Installed
opvxg4xx: Powering up all spans...
ACPI: PCI Interrupt 0000:0c:02.0[A] -> GSI 17 (level, low) -> IRQ 177 <

---

ERRO!
Found an OpenVox G400P: Version 1.0
opvxg4xx: slot 0 is Installed
opvxg4xx: slot 1 is Installed
opvxg4xx: slot 2 is Installed
opvxg4xx: slot 3 is Installed
opvxg4xx: Powering up all spans...
dahdi_echocan_oslec: Registered echo canceler 'OSLEC'

What I noticed was in dmesg. Two plates and a G400E and G400P with the same irq. I think it is not normal, is not it?

Yes, it's not normal, how many PCI slots of your system? Did you remove one of cards to another's PCI slot and see what happens? In order to fix your problem quickly, I would like to get access to your system now. Could I have this permission? And please tell me what's your IM account?

Joe,

I did, reinstalled the dahdi and worked perfectly.
But now another problem arose, gave an error in oslec.
I had to load mg2 but I try problem with the echo.

Thanks,

Marcelo.

Marcelo,

Can you insert this command below in /etc/openvox/opvxg4xx/modules/m20.conf on line 67?

AT+QECHO=221,2048,0,849,0

Save and exit, then restart driver and Asterisk.

Hi Joe,

Oslec managed to install, works perfectly.
The links that leave the G400P do not have echo!
Only links that leave the G400E pci-exp is presenting echo!
Already has changed the m20.conf, but not resolved!

Thanks,

Marcelo.